Dripping Faucet Calculator: What a Leaky Tap Really Wastes
One drip a second adds up to bathtubs.
A dripping tap seems harmless until you count the drips. Enter how many drips fall each minute and how big each one is, and this calculator shows the water lost per day, month and year, along with its cost and some everyday comparisons. The table shows five drip rates, from a slow weep to a steady trickle.
Your details
Try an example
Result
Water wasted
788 litres a year
2.2 litres a day · $2.76 a year
- Per day
- 2.2 L
- Per month
- 66 L
- Water cost per year
- $2.76
Good to know: litres per day = drips per minute × ml per drip × 1,440 ÷ 1,000
The numbers behind this · totals, working, notes
- In US gallons per year
- 208
- Bathtubs per year (150 L)
- 5
- Drinking-water bottles (500 ml)
- 1,577
How it was worked out
- Litres per day = drips per minute × ml per drip × 1,440 minutes ÷ 1,000
- Litres per year = per day × 365
- Count drips for one minute to get your rate. A drip is 20 per millilitre on average, so the default of 0.05 ml is typical, but fixtures vary. A hot tap also wastes the energy used to heat the water, which is not counted unless you track it separately.
Waste at other drip rates
Same drip size, different rates. Yours is highlighted.
| Drips per minute | Per day | Per year | Cost per year |
|---|---|---|---|
| 10 | 0.7 L | 263 L | $0.92 |
| 30 | 2.2 L | 788 L | $2.76 |
| 60 | 4.3 L | 1,577 L | $5.52 |
| 120 | 8.6 L | 3,154 L | $11.04 |
| 600 | 43.2 L | 15,768 L | $55.19 |
The idea behind it
What is going on inside the dripping faucet calculator
01Count
Time a minute of drips
Place a cup under the tap and count drips for one minute, or measure the water collected, to get an accurate rate for the calculation.
02Drop size
Drips vary in size
A typical drip is 0.05 to 0.1 ml. Bigger drips from a low-pressure tap waste more, so measure the water if you can.
03Fix
Often a cheap repair
Dripping taps are usually caused by a worn washer or cartridge, which costs little to replace compared with the water wasted over a year.
Five drip rates, five yearly losses
Waste scales directly with the drip rate, so a tap that drips once a second wastes six times as much as one that drips every six seconds. Rates below assume a 0.05 ml drip and the default water price.
| Drip rate | Per day | Per month | Per year | Bathtubs a year |
|---|---|---|---|---|
| One drip every 6 seconds | 0.7 L | 22 L | 263 litres a year | 2 |
| One drip every 2 seconds | 2.2 L | 66 L | 788 litres a year | 5 |
| One drip a second | 4.3 L | 131 L | 1,577 litres a year | 11 |
| Two drips a second | 8.6 L | 263 L | 3,154 litres a year | 21 |
| A steady trickle | 43.2 L | 1,313 L | 15,768 litres a year | 105 |
A real drip is between about 0.05 and 0.1 ml, so a bigger drop doubles these totals. Hot-water drips also waste the energy used to heat the water.
Drips per minute, volume and price
- Count the drips in one minute and enter the rate.
- Leave the drop size at 0.05 ml, or enter your own measurement.
- Enter your water price per cubic metre.
- Read the water wasted per day and year, the cost and the table of other drip rates.
30 drips a minute, 0.05 ml each
A tap dripping 30 times a minute with 0.05 ml drops wastes 2.16 litres a day, which is about 788 litres a year and costs roughly 2.76 at 3.50 per cubic metre.
The formula and reference values
Formula
litres per day = drips per minute × ml per drip × 1,440 ÷ 1,000
Judging a leak by how loud it is
- Counting drips for a few seconds only.
- Assuming all drips are the same size.
- Forgetting hot water has an energy cost too.
- Ignoring a faster flow that is nearly a stream.
Leaky tap questions
How much water does a dripping tap waste?
A tap that drips 30 times a minute wastes roughly 800 litres a year. Faster drips waste much more, and a fine stream can waste thousands.
How much water does a dripping tap waste?
A tap dripping 30 times a minute wastes roughly 800 litres a year. A faster drip wastes proportionally more, and a thin stream can waste many thousands of litres.
How big is one drop of water from a tap?
Typically 0.05 to 0.1 ml, which is 10 to 20 drops per millilitre. Measure over a minute if you want precision.
Is it worth fixing a dripping tap?
Usually yes. A worn washer or cartridge costs little, and the saving in water and, for a hot tap, energy repays it quickly.
Related tools
- Water Demand CalculatorEstimate how much water a household uses each day from showers, toilets, machines, taps and the garden.
- Tap Water vs Bottled Water CalculatorSee how much you could save, and how much plastic you would avoid, by drinking tap water instead of bottled.
- Passive House Savings CalculatorSee how much heating energy, money and CO₂ a very low-energy building would save compared with your current home.
- Solar Panel CalculatorWork out how many solar panels you need, what they cost, how much they save and when they pay back.
How we calculate this
We use the standard published formula or definition for this calculation, and we show the working so you can check it.
Spotted a mistake? Tell us and we'll check it. How we check our calculators